Power over Ethernet HAT for Raspberry Pi 3B+ and 802.3af PoE network – Waveshare

Power over Ethernet HAT for Raspberry Pi 3 Model B+, 802.3af power-sourcing equipment required

Key Features

802.3af PoE
Fully isolated switched-mode power supply
37x57V DC, Class 2 device
5V/2.5A DC output
25mm x 25mm brushless fan for processor cooling
Fan control

How to:

Hardware Required

Raspberry Pi PoE HAT
A Raspberry Pi 3 Model B+
An Ethernet cable
Power-sourcing equipment for a 802.3af Power over Ethernet network

Connecting your PoE HAT to the Raspberry Pi

Before installing the PoE HAT, you must attach the supplied spacers in the four corners of the board
Then connect the Raspberry Pi PoE HAT to the two 0.1″ headers (40 + 4) that are fitted on the Raspberry Pi
Once the PoE HAT board is connected, you can power the Raspberry Pi through its RJ45 network connector
The fan will turn on and off automatically depending on the temperature of the main processor on the Raspberry Pi.

Disconnecting your PoE HAT
Pull evenly so that it detaches from all the pins at the same rate; do not pull one end of the connector off before the other

Dimension