Adafruit QT Py ESP32-S3 WiFi Dev Board 8MB Flash / No PSRAM

The ESP32-S3 emerges as a remarkably compact and energy-efficient 2.4 GHz Wi-Fi System-on-Chip (SoC) solution, now bolstered by WiFi and BLE support. It also introduces new features like built-in native USB and Time of Flight distance measurements. Displaying exceptional power and RF capabilities, this SoC stands as an optimal selection across a diverse range of applications within the realms of Internet of Things (IoT), wearable technology, and intelligent home systems.
Equipped with native USB and an 8 MB Flash, this board facilitates seamless enhancements to your existing ESP32 projects. Its native USB functionality enables it to emulate a keyboard or disk drive without necessitating an external USB-to-Serial converter. The combination of WiFi and BLE renders it particularly suitable for the realization of impressive IoT endeavors.
Features

Same size, form-factor, and pin-out as Seeed Xiao

USB Type C connector

ESP32-S3 Dual Core 240MHz Tensilica processor- the next generation of ESP32-Sx, with native USB so it can act like a keyboard/mouse, MIDI device, disk drive, etc!

Comes with8MB Flash, 512KB SRAM, no PSRAM

Native USB supported by every OS- can be used in Arduino or CircuitPython as USB serial console, MIDI, Keyboard/Mouse HID, even a little disk drive for storing Python scripts.

Can be used withArduino IDEorCircuitPython

Built-in RGB NeoPixel LEDwith power control to reduce quiescent power in deep sleep

Battery input pads on underside with diode protection for external battery packs up to 6V input

13GPIO pins:

11 on breakout pads, 2 more on QT connector
10 x 12-bit analog inputs (SPI high speed padsdo not have analog inputs)
PWM outputs on any pin
Two I2C ports, one on the breakout pads, and anotherwith STEMMA QT plug-n-play connector
Hardware UART
Hardware SPI on the high speed SPI peripheral pins
Hardware I2S on any pins
5 x Capacitive Touch with no additional components required

3.3V regulator with600mA peak output

Light sleep at 2~4mA,deep sleep at ~70uA

Reset switchfor starting your project code over, boot 0 button for entering bootloader mode

Really really small

Resources

ESP32-S3FN8 Datasheet

Primary Guide: Adafruit QT Py ESP32-S3