Adafruit QT Py ESP32-S2 WiFi Development Board

The Adafruit QT Py ESP32-S2 WiFi Development Board integrates ESP32-S2 which is a low-power, 2.4 GHz Wi-Fi System-on-Chip (SoC) solution that now has built-in native USB as well as some other interesting new technologies like Time of Flight distance measurements. QT Py ESP32-S2 has a single-core 240 MHz chip, so it won’t be as fast as ESP32’s with dual-core and there is no Bluetooth support.
Features

USB Type C connector
ESP32-S2 240MHz Tensilica processor- the next generation of ESP32, now with native USB so it can act like a keyboard/mouse, MIDI device, disk drive, etc!
4 MB Flash & 2 MB PSRAM
Native USB supported by every OS- can be used in Arduino or CircuitPython as USB serial console, MIDI, Keyboard/Mouse HID, even a little disk drive for storing Python scripts.
Can be used withArduino IDEorCircuitPython
Built-in RGB NeoPixel LEDwith power control to reduce quiescent power in deep sleep
Battery input pads on underside with diode protection for external battery packs up to 6V input
13GPIO pins:

11 on breakout pads, 2 more on QT connector
10 x 12-bit analog inputs (SPI high speed padsdo not have analog inputs)
8-bit analog output DAC
PWM outputs on any pin
Two I2C ports, one on the breakout pads, and anotherwith STEMMA QT plug-n-play connector
Hardware UART
Hardware SPI on the high speed SPI peripheral pins
Hardware I2S on any pins
5 x Capacitive Touch with no additional components required

3.3V regulator with600mA peak output
Light sleep at 2~4mA,deep sleep at ~70uA
Reset switchfor starting your project code over, boot 0 button for entering bootloader mode

STEMMA QT / Qwiic 4-pin 1mm Pitch White Female Connector Cable 150mm Long – Both Sidecan be purchased seperately.
Resources
Primary Guide: Adafruit QT Py ESP32-S2